Standard Test Methods for Determining Small-Strain Tensile Properties of Geogrids and Geotextiles by In-Air Cyclic Tension Tests

Importancia y uso:

5.1 Test Methods A, B, and C provide a means of evaluating the tensile modulus of geogrids and geotextiles for applications involving small-strain cyclic loading. The test methods allow for the determination of cyclic tensile modulus at different levels of prescribed or permanent strain, thereby accounting for possible changes in cyclic tensile modulus with increasing permanent strain in the material. These test methods shall be used for research testing and to define properties for use in specific design methods.

5.2 In cases of dispute arising from differences in reported test results when using these test methods for acceptance testing of commercial shipments, the purchaser and supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student’s t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing began. If a bias is found, either its cause shall be found and corrected or the purchaser and supplier shall agree to interpret future test results in light of the known bias.

5.3 All geogrids can be tested by Test Method A or B. Some modification of techniques may be necessary for a given geogrid depending upon its physical makeup. Special adaptations may be necessary with strong geogrids, multiple-layered geogrids, or geogrids that tend to slip in the clamps or those which tend to be damaged by the clamps.

5.4 Most geotextiles can be tested by Test Method C. Some modification of clamping techniques may be necessary for a given geotextile depending upon its structure. Special clamping adaptations may be necessary with strong geotextiles or geotextiles made from glass fibers to prevent them from slipping in the clamps or being damaged as a result of being gripped in the clamps.

5.5 These test methods are applicable for testing geotextiles either dry or wet. It is used with a constant rate of extension type tension apparatus.

5.6 These test methods may not be suited for geogrids and geotextiles that exhibit strengths approximately 100 kN/m (600 lbf/in.) due to clamping and equipment limitations. In those cases, 100-mm (4-in.) width specimens may be substituted for 200-mm (8-in.) width specimens.

Subcomité:

D35.01

Volúmen:

04.13

Número ICS:

59.080.40 (Coated fabrics)

Palabras clave:

geogrid; geogrid rib; geosynthetic; geotextile; index test; tensile test;