Standard Test Method for Laboratory Measurement of Impact Sound Transmission Through Floor-Ceiling Assemblies Using the Tapping Machine

Importancia y uso:

5.1 The spectrum of the noise in the room below the test specimen is determined by the following:

5.1.1 The size and the mechanical properties of the floor-ceiling assembly, such as its construction, surface, mounting or edge restraints, stiffness, or internal damping,

5.1.2 The acoustical response of the room below,

5.1.3 The placement of the object or device producing the impacts, and

5.1.4 The nature of the actual impact itself.

5.2 This test method is based on the use of a standardized tapping machine of the type specified in 8.1 placed in specific positions on the floor. This machine produces a continuous series of uniform impacts at a uniform rate on a test floor and generates in the receiving room broadband sound pressure levels that are sufficiently high to make measurements possible beneath most floor types even in the presence of background noise. The tapping machine itself, however, is not designed to simulate any one type of impact, such as produced by male or female footsteps.

5.3 Because of its portable design, the tapping machine does not simulate the weight of a human walker. Therefore, the structural sounds, i.e., creaks or booms of a floor assembly caused by such footstep excitation is not reflected in the single number impact rating derived from test results obtained by this test method. The degree of correlation between the results of tapping machine tests in the laboratory and the subjective acceptance of floors under typical conditions of domestic impact excitation is uncertain. The correlation will depend on both the type of floor construction and the nature of the impact excitation in the building.

5.4 In laboratories designed to satisfy the requirements of this test method, the intent is that only significant path for sound transmission between the rooms is through the test specimen. This is not generally the case in buildings where there are often many other paths for sounds— flanking sound transmission. Consequently sound ratings obtained using this test method do not relate directly to sound isolation in buildings; they represent an upper limit to what would be measured in a field test.

5.5 This test method is not intended for field tests. Field tests are performed according to Test Method E1007.

Subcomité:

E33.10

Referida por:

E1749-18R25, E2964-21, C0926-24, E2179-21, C0926-24, C0842-05R25, E0989-21, E0090-23, E3222-20A, E3207-21, C0844-15R21, E2235-04R20, E3091-17R24, C0634-22, C0841-23, E2813-24, E0966-18A, E1007-25, E0336-25

Volúmen:

04.06

Número ICS:

91.120.20 (Acoustics in buildings. Sound insulation)

Palabras clave:

floor ceiling assemblies; impact sound transmission; tapping machine;