Standard Practice for Sampling a Stream of Product by Variables Indexed by AQL

Importancia y uso:

5.1 This practice was prepared to meet a growing need for the use of standard sampling plans for inspection by variables in customer procurement, supply and storage, and maintenance inspection operations. The variables sampling plans apply to a single quality characteristic which can be measured on a continuous scale, and for which quality is expressed in terms of percent defective. The theory underlying the development of the variables sampling plans, including the operating characteristic curves, assumes that measurements of the quality characteristic are independent, identically distributed normal random variables.

5.2 In comparison with attributes sampling plans, variables sampling plans have the advantage of usually resulting in considerable savings in sample size for comparable assurance as to the correctness of decisions in judging a single quality characteristic, or for the same sample size, greater assurance is obtained using variables plans. Attributes sampling plans have the advantage of greater simplicity, of being applicable to either single or multiple quality characteristics, and of requiring no knowledge about the distribution of the continuous measurements of any of the quality characteristics.

5.3 It is important to note that variables sampling plans are not to be used indiscriminately, simply because it is possible to obtain variables measurement data. In considering applications where the normality or independence assumptions may be questioned, the user is advised to consult his technical agency to determine the feasibility of application.

5.4 Application—Sampling plans designated in this publication are applicable, but not limited, to inspection of the following: (1) end items, (2) components and raw materials, (3) operations or services, (4) materials in process, (5) supplies in storage, (6) maintenance operations, (7) data or records, and (8) administrative procedures.

Subcomité:

E11.30

Referida por:

F3635-23, E0456-13AR22E01, F3554-22, F3607-22, E2910-24, E2910-24, E2587-25

Volúmen:

14.01

Número ICS:

07.020 (Mathematics)

Palabras clave:

acceptability constant; acceptability criterion; acceptable quality level; classification of defects; critical defects; inspection; inspection by attributes; inspection by variables; lot; lot size; major defects; minor defects; mixed variables-attributes inspection; percent defective; quality characteristic; sampling plans; specification limits; unit of product;