Standard Guide for Testing Coating Powders and Powder Coatings

Importancia y uso:

4.1 This guide provides a useful summary to the selection and use of procedures for testing coating powders and powder coatings. It is applicable to both thermoplastic and thermoset coatings, unless indicated otherwise. By design this guide does not purport to address test methods or procedures developed specifically for the functional powder coating market, those coating powders for application to pipe or reinforced steel bars (rebar). Information on current test procedures for pipe and reinforced steel bar coating powders and powder coatings can be obtained through their respective ASTM Subcommittees, A01.05 and D01.48.

4.2 Selection of the methods to be followed and the interpretation of results must be governed by experience and the requirements in each individual case, together with agreement between the purchaser and seller. It should be noted that many of the methods used for characterizing a coating powder, such as gel time (Section 16) and inclined flow (Section 17), are primarily meant for the relative comparison of two coating powders, rather than to give a test value that can be interpreted as good or bad. Interpretation of the test results will depend on the specific application in question and will also often depend on the chemistry of the coating powder used.

Subcomité:

D01.51

Referida por:

D5861-07R17, D6441-05R24, G0195-22, D2832-92R16

Volúmen:

06.02

Número ICS:

13.300 (Protection against dangerous goods)

Palabras clave:

accelerated testing; coating powders; cured weight loss; gel time; optical properties; particle size distribution; plate flow; powder coatings; transfer efficiency;