Standard Test Method for Determining Tensile Properties of Geogrids by the Single or Multi-Rib Tensile Method

Importancia y uso:

5.1 The determination of the tensile force-elongation values of geogrids provides index property values. This test method shall be used for quality control and acceptance testing of commercial shipments of geogrids.

5.2 In cases of dispute arising from differences in reported test results when using this test method for acceptance testing of commercial shipments, the purchaser and supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing began. If a bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias.

5.3 All geogrids can be tested by any of these methods. Some modification of techniques may be necessary for a given geogrid depending upon its physical makeup. Special adaptations may be necessary with strong geogrids, multiple layered geogrids, or geogrids that tend to slip in the clamps or those which tend to be damaged by the clamps.

Subcomité:

D35.01

Referida por:

D8212-24E01, D6461_D6461M-22, D6916-18, D4355_D4355M-21, D6638-18, E2777-20, D8105-18, D5262-21

Volúmen:

04.13

Número ICS:

59.080.70 (Geotextiles)

Palabras clave:

geogrid; geogrid rib; geosynthetic; geotextile; index test; tensile test;