Standard Test Method for End (Warp) and Pick (Filling) Count of Woven Fabrics

Importancia y uso:

5.1 This test method is considered satisfactory for acceptance testing of commercial shipments because it has been used extensively in the trade for that purpose.

5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.

5.1.2 This test method is suitable for use with narrow fabrics when the count across the total width is measured in the narrow direction and extrapolated to the number of yarns per centimeter (inch).

Subcomité:

D13.60

Referida por:

D6337-98R19, D1464-12R24, D4029_D4029M-23, D1668_D1668M-97AR21, D4850-23, D0580_D0580M-24, D4851-07R19E01, D0173_D0173M-03R24, D0579_D0579M-24, D3656_D3656M-13R21, D7507-23, D4389_D4389M-23, D2646-24, D4028_D4028M-13R21, D6674-01R17, D5446-08R19

Volúmen:

07.01

Número ICS:

59.080.30 (Textile fabrics)

Palabras clave:

construction; end count; fabric; pick count; woven;