Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar (Metric)

Importancia y uso:

11.1 For the purposes of determining compliance with the specified limits for requirements of the properties listed in the following table and for dimensional tolerances, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29:

Property

Rounded Unit for Observed or
Calculated Value

  Chemical composition

  nearest unit in the last

  Hardness

   right-hand significant digit

  Electrical resistivity

   used in expressing

  Electrical conductivity

   the limiting value

  Tensile strength

  nearest 5 MPa

  Yield strength

  nearest 5 MPa

  Elongation:

  nearest 1 %

  Grain size:

   Under 0.060 mm

  nearest multiple of 0.005 mm

   0.060 mm and over

  nearest 0.01 mm

Subcomité:

B05.01

Referida por:

B0103_B0103M-23, B0169_B0169M-20, B0888_B0888M-24, B0950-23, B0694-19, B0768-22, B0534-20, B0130-24, B0740-21, B0194-22, B0036_B0036M-23, B0422_B0422M-22, B0096_B0096M-20, B0121_B0121M-23, B0936-23, B0171_B0171M-18, B0248-22, B0152_B0152M-24, B0122_B0122M-20

Volúmen:

02.01

Número ICS:

77.150.30 (Copper products)

Palabras clave:

general requirements, plate; general requirements, rolled bar; general requirements, sheet; general requirements, strip; general requirements, wrought copper and copper alloys;