Standard Practice for Determining Allowable Tensile Load for Polyethylene (PE) Gas Pipe During Pull-In Installation

Importancia y uso:

4.1 The ATL value is used to set the break-away strength of a weak-link device, or to set other equipment used to limit pulling force during pull-in installation of polyethylene gas pipe, or to determine if pulling equipment can exert pulling force greater than the ATL value for the polyethylene gas pipe being installed.

4.2 The ATL value is determined before gas pipe installation.

Subcomité:

F17.60

Referida por:

F0585-16R21, F1962-22

Volúmen:

08.04

Número ICS:

23.040.20 (Plastic pipes)

Palabras clave:

gas pipe; polyethylene; pull-in installation;