Standard Practice for Determining Sandwich Beam Flexural and Shear Stiffness

Importancia y uso:

5.1 Flexure tests on flat sandwich constructions may be conducted to determine the sandwich flexural stiffness, the core shear strength and shear modulus, or the facing’s compressive and tensile strengths. Tests to evaluate core shear strength may also be used to evaluate core-to-facing bonds.

5.2 This practice provides a standard method of determining sandwich flexural and shear stiffness and core shear modulus using calculations involving measured deflections of sandwich flexure specimens. Tests can be conducted on short specimens and on long specimens (or on one specimen loaded in two ways), and the flexural stiffness, shear rigidity, and core shear modulus can be determined by simultaneous solution of the complete deflection equations for each span or each loading. If the facing modulus values are known, a short span beam can be tested and the calculated bending deflection subtracted from the beam's total deflection. This gives the shear deflection from which the transverse shear modulus can be determined.

Note 1: Core shear strength and shear modulus are best determined in accordance with Test Method C273, provided bare core material is available.

Note 2: For cores with high shear modulus, the shear deflection will be quite small and ordinary errors in deflection measurements will cause considerable variations in the calculated shear modulus.

Note 3: To ensure that simple sandwich beam theory is valid, a good rule of thumb for a four-point bending test is the span length divided by the sandwich thickness should be greater than 20 (L₁/d > 20) with the ratio of facing thickness to core thickness less than 0.1 (t/c < 0.1).

Subcomité:

D30.09

Referida por:

D7249_D7249M-20, C0393_C0393M-20, D4762-23

Volúmen:

15.03

Número ICS:

79.060.01 (Wood-based panels in general)

Palabras clave:

core shear modulus; flexural stiffness; sandwich construction; sandwich deflection; shear rigidity; shear stiffness;